Table of Contents
Advertisement
Provides a subset of MP CLI commands
Provides access to the MP Main Menu interface and the system console interface
For detailed information about SMASH CLP use, see:
http://docs.hp.com/en/5971-4292/ch1 1.html
Configures security options and access control (for example, users and passwords).
SO
This command modifies the security parameters of the MP, which include login timeouts
and allowed password faults.
If configured, when you access the MP through the modem port, the MP hangs up and
dials you back. This does not work if Modem Presence is set to not always connected
with the CA command. If the mode is single, the state is changed to disabled after the
first login. A user whose login is disabled is not accepted.
Displays the status of the system processors and identifies the monarch processor.
SS
Displays the revision status of firmware in the system.
SYSREV
System resets through INIT or Transfer of Control (TOC) signal. Shut down the operating
TC
system before issuing this command.
This command causes the system to be reset through the INIT or TOC signal. Execution
of this command irrecoverably halts all system processing and I/O activity and restarts
the computer system. It is different from the RS command in that the processors are
signaled to dump state on the way down.
Tell. Sends a message to other terminals. You can enter up to 80 characters. The
TE
message is broadcast to the other mirrored clients. Users in a session or CSP are not
shown the message.
User Configuration. Controls user access. Use this command to add, modify, re-enable,
UC
or delete user logins. You can also enable or disable security warnings and change
passwords.
Displays Virtual Front Panel. The VFP command presents a summary of the system by
VFP
using direct console addressing. If the terminal is not recognized by the MP, VFP mode
is rejected. Each individual user gets this summary to avoid issues related to terminal
type and screen display mode.
Displays a list of MP connected users. This command displays the login name and
WHO
operating mode (Main Menu, command, and so on) of the connected console client
users, and the port on which they are connected. For the LAN and WEB console clients,
the command also displays the remote IP address.
If the local console client user did not originate the MP command interface session,
there is always one default user listed for the local serial port: local user i. If the local
console operator enters CTRL+B, the login name that the local operator used displays
instead.
Exits MP command interface and disconnect from the system. This command disconnects
X
the executing user from the system. This command is available from the local port.
Diagnostics or Reset of MP. Use this command to perform some simple checks to confirm
XD
the health and connectivity status of the MP. The following tests are available:
MP Parameter Checksum
Verify I2C connection (get BMC Device ID)
LAN connectivity test using ping
Modem self-tests
MP Commands
13
Advertisement
Table of Contents
