Table of Contents
Advertisement
Displays FRUID information. This command displays FRUID information from the BMC
DF
for FRU devices. Information provided includes serial number, part number, model
designation, name and version number, and manufacturer.
Disconnects remote/modem or LAN/WEB console. This command disconnects (hangs
DI
up) the remote/modem or LAN/WEB users from the MP. It does not disable the ports.
The remote console is no longer mirrored.
Activates MP firmware upgrade mode. This command is available from either the LAN
FW
or a local serial port. This command activates firmware upgrade mode, which loads
new firmware through the MP LAN by FTP (which must be operational). An MP reset
is generated after the upgrade is complete.
Displays help for menu or command. This command displays the MP hardware and
HE
firmware version identity, and the date and time of firmware generation. If executed
from the MP Main Menu, this command displays general information about the MP
and those commands displayed in the MP Main Menu. If executed in command mode,
this command displays a list of command interface commands available to you. It also
displays detailed help information in response to a topic or command at the help prompt.
Displays and modifies the following system information:
ID
Inactivity Timeout settings. The maximum session inactivity timeout is 1,440 minutes.
IT
The default is 60 minutes. This timeout prevents sessions from being inadvertently left
open. You can start a session with the SE command. An open session can prevent users
from logging into the MP through a port and can also prevent system applications from
initiating an outbound connection.
The maximum MP inactivity timeout is 1,440 minutes. The default is 5 minutes. This
timeout prevents a user from inadvertently keeping the MP locked in an MP command
interface mode, and preventing other users from looking at the console output. You
cannot deactivate the MP command interface inactivity timeout
The flow control timeout is 0 to 60 minutes. If set to 0, no timeout is applied. This timeout
prevents mirrored flow control from blocking other ports when inactive.
LAN configuration (IP address and so on). This command displays and allows
LC
modification of the following LAN configuration parameters:
10
Management Processor
Disable remote access, security configuration
Session configuration, for example, setting the security configuration to default
erases all users and passwords
You can reset passwords in the MP in one of the following ways:
Using the SO command, change individual users.
◦
◦
Using the DC command, select Reset Security Configuration.
◦
Reset forgotten passwords by pressing the MP reset button on the back panel
of the HP server. After the MP reboots, the local console terminal displays a
message for 5 seconds. Responding to this message in time allows a local
user to reset the password.
NOTE:
All user information (for example, logins and passwords) is erased in
methods 2 and 3.
SNMP contact information
SNMP server information
SPU host name
Advertisement
Table of Contents
