4. Adhere the mylar tape (C) to secure the eDP cable to the LCD panel
Figure 1-76. Replacing the LCD Panel
5. Adhere the double-sided adhesive mounting tapes (D) on both sides of the LCD
hinges and press each tape for about 30 seconds. Then peel off the protective film
from the double-sided adhesive mounting tapes
NOTE:
NOTE:
Before applying the new double-sided adhesive mounting tapes, make sure to
clean the surface properly with the rubbing alcohol. Then attach the adhesive
mounting tapes onto the designated slots as shown in the below illustration
(Figure
1-77).
Figure 1-77. Replacing the LCD Panel
Machine Maintenance Procedures
C
(Figure
D
(Figure
1-76).
1-77).
1-60