Setting The Domain Name - Ingenico i6780 User Manual

Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Sys Parameters
Download Method
Download Port
Setup Port
Setup Port
Port1
Port2
Port3
Port3
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
DHCP
Local IP
Local IP Port
Server IP
Server IP Port
IP Add Mask
Gateway
Primary DNS
Secondary DNS
Secondary DNS
XXX.XXX.XXX.XXX
Updating...

Setting the Domain Name

6.4.20
If you are using Ethernet, and DHCP is set to None, you will need to set the domain name to
use. Domain names are the human-readable addresses used on the Internet (e.g.,
www.microsoft.com). The Domain Name Service (DNS) translates these names into IP
addresses which TCP/IP programs use directly.
Display
Ingenico 6780 User's Guide
Tap Sys Parameters.
Tap Setup Port.
Tap Port3, Ethernet.
Tap ▼ until you reach Secondary DNS, then tap
Secondary DNS.
Enter the address of the secondary DNS.
Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
59