Fisher & Paykel WASHSMART ECO Installation Manual/User Manual page 8

Levelling instructions
It is IMPORTANT to level the washer to ensure good spin performance.
A level is provided with your washer. The washer is level when the bubble sits in the centre,
within the two lines.
Your washer is equipped with self-locking feet at the front to ensure they do not move once
you have levelled your washer. Move the washer using the top corners, do not push the
centre front of the washer.
After levelling, the corners of the washer should be clear of the floor and the washer must
not rock in any direction.
1
Level
2
3
4
8
INSTALLATION INSTRUCTIONS
100mm
Wall
Level
If moving or transporting your washer ensure you
tape the lid down.
Move the washer to its final position allowing
for required clearances.
Level the washer side to side:
Open the lid and place level at the centre
z
front of the top deck (forward of the lid
lock slot). Wind the front feet up or down.
Release the rear feet:
Close the lid and tilt washer forward away
z
from the wall. Gently lower washer down.
Level the washer front to back:
Open the lid and place the level on
z
one side of the top deck. Wind both
front feet equally.
To release back feet, tilt the
z
washer forward.
Re-check the washer is level:
Place the level at the centre front of the
z
topdeck (forward of the lid lock slot).
Ensure washer does not rock
z
in any direction.
If washer is not level repeat
z
the above steps.