Fisher & Paykel WASHSMART ECO Installation Manual/User Manual page 11

Completing your installation
Turn on the water and check all hose connections for leaks. Make sure there are no kinks
z
in the hoses. Check the hose connections for leaks again after 24 hours.
Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
z
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
z
Installation test cycle
Your washer must be correctly installed before use. Check the installation and operation of
the washer using the following procedure:
1
2
3
If you need further assistance, please contact a Fisher & Paykel trained and supported
service technician or our Customer Care Centre. Refer to 'Customer care' section for
contact details.
Note: WA7060M QuickSmart™ washer only — a manual check of the inlet hose connections
will be required as the installation test cycle will not verify if the hot and cold inlet hoses are
connected the correct way around.
INSTALLATION INSTRUCTIONS
+
Touch to activate your washer.
Touch both the and
same time, and hold for 3 seconds.
Touch to start the installation test cycle.
The display will show
The washer will beep to signal the end of
the installation test cycle. Any faults will be
displayed on the screen (refer to the back of
this user guide to help identify faults).
buttons at the
OPTIONS
.
11