Table of Contents
Advertisement
Electric Shock Hazard
Failure to follow this advice may result in
electrical shock or death.
• Before carrying out any work on the electrical
section of the appliance, it must be disconnected
from the mains electricity supply.
• Connection to a good ground wiring system is
absolutely essential and mandatory.
• Alterations to the domestic wiring system must
only be made by a qualified electrician.
Cut Hazard
Failure to use caution could result in injury.
• Take care – some edges are sharp.
Fire Hazard
Failure to follow this advice may result in a fire
causing death or serious injury.
• Do not use adapters, reducers, or branching
devices to connect this appliance to the mains
power supply.
WARNING!
To reduce the risk of fire, injury to persons or damage when using the appliance, follow the
important safety instructions listed below. Read all the guidance before using the appliance.
Servicing
Do not repair or replace any part of the appliance unless specifically recommended in
z
the user guide. All other servicing should be undertaken be a Fisher & Paykel trained and
supported service technician or qualified person.
2
WARNING!
!
WARNING!
!
WARNING!
!
SAFETY AND WARNINGS
General
Save these instructions for the local inspectors use.
z
Please make this information available to the person installing the appliance – doing
z
so could reduce your installation costs.
This oven is to be installed and connected to the electricity supply only by an
z
authorized person.
If the installation requires alterations to the domestic electrical system, call a qualified
z
electrician. The electrician should also check that the socket cable section is suitable
for the electricity drawn by the oven.
The oven must be grounded.
z
Installation must comply with your local building and electricity regulations.
z
This appliance must be installed and connected to the mains power supply only by a
z
suitably qualified person according to these installation instructions and in compliance
with any applicable local building and electricity regulations. Failure to install the
appliance correctly could invalidate any warranty or liability claims.
If the power supply cable is damaged, it must be replaced by the manufacturer, its service
z
agent or similarly qualified person in order to avoid a hazard.
A circuit breaker is recommended.
z
Do not use adaptors, reducers or branching devices to connect the oven to the mains
z
electricity supply, as they can cause overheating and burning.
Make sure the cavity is completely sealed with no gaps. This is to ensure the oven cooling
z
system functions correctly.
Do not allow children and animals to stop or linger near the appliance when it is pulled
z
out of the cabinet.
Electrical requirements
Connect oven with copper wire only.
z
Do not cut the conduit.
z
A U.L. listed conduit connector must be provided at the junction box.
z
Do not ground to a gas pipe.
z
Do not have a fuse in the grounding or neutral circuit.
z
Fuse both sides of the line.
z
A time delay fuse or circuit breaker is recommended. If using a time delay fuse, then
z
fuse both sides of the line.
Flexible armored cable from the appliance should be connected directly
z
to the junction box.
Connect directly to the fused disconnect (or circuit breaker box) through flexible, armored
z
or non-metallic sheathed, copper cable (with grounding wire).
If codes permit and a separate grounding wire is used, it is recommended that a
z
qualified electrician determine that the grounding path and wire gauge are in
accordance with local codes.
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to
change at any time. For current details about model and specification availability in your country,
please go to our website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.
Advertisement
Table of Contents
