I Memory Names; I Clearing The Memory Contents - Icom IC-A24 Instruction Manual

I Memory names

ï Programming memory names
The memory channel can display a 6-character names in-
stead of the programmed frequency.
q Rotate [DIAL] to select the desired frequency in the fre-
quency mode.
w Push
, then push [MR•
into the selected memory channel.
e Rotate [DIAL] to select the desired memory channel to be
programmed.
• Push [0• ] to select the BANK number if desired. Push
BANK
[CLR• ] to exit the BANK selection mode.
DEL
r Push [MR•
] to enter the memory name programming
MW
mode.
• "-- -- -- -- -- -- " appears on the display.
t Push the appropriate digit key several times to select the
desired character as listed at right.
• To erase a character, overwrite with a space (displayed as _).
• To move the cursor forwards or backwards, use [DIAL].
y Push [ENT•
] to program the name.
WX
• Flashing the memory name stops.
• When no name is programmed, the display shows the operating
frequency.
• To clear the programmed memory names, push [CLR•
fore pushing [ENT• ].
WX
] to program the contents
MW
] be-
DEL
MEMORY OPERATION
Key Character Key
1 1, Q, Z 2
4 4, G, H, I 5
7 7, P, R, S 8
ENT Program 0

I Clearing the memory contents

Unwanted memory channels can be cleared. Programming
over a memory channel also clears the previously pro-
grammed contents. Memory channel 1 cannot be cleared.
q Select the memory channel to be cleared.
w Push
, then push and hold [CLR•
• "-- -- -- -- -- --" appears momentarily, then the next selec-
table channel appears.
Character Key Character
2, A, B, C 3 3, D, E, F
5, J, K, L 6 6, M, N, O
8, T, U, V 9 9, W, X, Y
0, space, -
] for 1 sec.
DEL
4
4
14