Fisher & Paykel FABRICSMART WA8560P Installation Manual/User Manual page 41

PROBLEM DISPLAYED AS
The washer is
out of balance.
The washer has
too many suds.
The lid can't
lock or the lid
is open.
The washer
is overloaded.
The washer
has stopped.
The washer
has stopped.
The washer is on
but the display
is blank.
BEFORE YOU CALL FOR SERVICE
WHAT TO DO
Wash load is out of balance. Ensure the washer is stationary.
Manually redistribute the load.
Check the washer is level (refer to 'Levelling instructions').
The washer has a suds build-up (too much detergent may have
been used for the amount of soil in the load). Wait for suds to
dissolve (about 20 min). Rinse clothes using a deep rinse.
Check the standpipe height does not exceed 1200 mm.
If the symptom persists, call your Fisher & Paykel dealer or
Fisher & Paykel trained and supported service technician.
Make sure the lid is closed.
Touch
If the symptom persists call your Fisher & Paykel dealer or
Fisher & Paykel trained and supported service technician.
The washer is overloaded and can not agitate. Ensure the
washer is stationary. Remove items until the remaining ones can
move freely.
Select a higher water level.
The power was cut to the washer. The washer will restart
automatically. No action is required.
The
for 3 minutes. The washer will automatically drain to a safe level.
Touch any button to stop autodraining then touch
the wash cycle.
The washer was unattended without starting a cycle for a period
of time. Touch
(refer to 'Lid lock').
or button was touched and the washer was inactive
to activate.
to resume
41