Table of Contents
Advertisement
Replacing the keyboard
Complete the following steps to replace a keyboard on the monitor and keyboard
tray assembly:
1. Remove the two back rubber pads from the bottom of the new keyboard and
2. Turn off the monitor; then, disconnect the monitor cord.
3. Disconnect the keyboard and mouse connectors from the server or console
4. Unscrew the thumbscrews; then, fully extend the monitor and keyboard tray.
5. Carefully lift the front of the flat-panel monitor and raise the monitor to the full
6. Remove the old keyboard from the keyboard tray.
discard them. (The rubber pads have an adhesive backing and can be peeled
from the surface.) If you leave the rubber pads on the keyboard, they will
extend into the 1-U space below.
Attention: Do not extend the keyboard feet. The flat-panel monitor screen
might be damaged if the feet are extended when the monitor is closed.
switch.
Remove the keyboard-and-mouse cable from the cable-management arm.
upright position.
Remove rubber pads
(two places)
Keyboard foot
Thumbscrews
Chapter 3. Hardware maintenance information
25
Advertisement
Table of Contents
