Table of Contents
Advertisement
8
IBM 17" 1 U Flat Panel Monitor Console Kit: Installation and Maintenance Guide
5. Carefully set the keyboard into the tray; then, route the keyboard-and-mouse
cable through the cord clip on the bottom, up through the opening on the
right side of the tray, and toward the cable-management arm. Pull the full
length of the cable through the opening.
6. Secure the keyboard-and-mouse cable to the cable-management arm using the
existing cable straps.
7. Select a 1-U location in the rack for the flat-panel monitor and keyboard tray.
Use the following illustration to guide you as you install either cage nuts or
clip nuts on the rack. Use the cage nuts or clip nuts from the miscellaneous
hardware kit.
Note: If you are planning to install an optional console switch, make sure that
you install a cage nut or clip nut in the center-rear position shown
shaded in the following illustration.
U
U
U
Front
Keyboard-and-mouse
cable routing
U
U
U
U
U
U
Optional console-switch nut
U
U
U
Rear
Advertisement
Table of Contents
