IBM T-117 Installation And Maintenance Manual page 16

17″ 1 u flat panel monitor console kit
Hide thumbs Also See for T-117:
Table of Contents

Advertisement

Statement 4:
DANGER
Complete the following steps to install the flat-panel monitor and keyboard tray
kit in a rack cabinet:
6
IBM 17" 1 U Flat Panel Monitor Console Kit: Installation and Maintenance Guide
Electrical current from power, telephone, and communication cables is
hazardous.
To avoid a shock hazard:
v Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical storm.
v Connect all power cords to a properly wired and grounded electrical outlet.
v Connect to properly wired outlets any equipment that will be attached to
this product.
v When possible, use one hand only to connect or disconnect signal cables.
v Never turn on any equipment when there is evidence of fire, water, or
structural damage.
v Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
v Connect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached devices.
To Connect:
1. Turn everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
1. Place the tray on a stable flat surface.
Attention: The video cable is connected to the flat-panel monitor. As you
install the tray in the rack cabinet, be careful that you do not pinch or cut the
video cable.
2. If your tray has a thin keyboard installed, go to step 7 on page 8.
To Disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.

Advertisement

Table of Contents
loading

Table of Contents