Moving The Printer - Ricoh InfoPrint 1532 User Manual

Ordering pick rollers
To order pick rollers, contact the place where you bought the printer for more information.
Order new pick rolls when the paper fails to properly feed from the tray.
When ordering pick rollers, you need one set per input tray excluding the multipurpose feeder.
Ordering staple cartridges
Staple cartridges hold 3,000 staples.To order this item, contact the place where you bought the printer for more information.
For information on clearing a staple jam, see Clearing staple
When Staples Low or Staples Empty appears on the operator panel display, insert a new staple cartridge in the finisher.
See the illustrations inside the stapler access door for more information.
If Staple Alarm is set to Single or Continuous, the alarm is sounded, the printer stops printing, and the Load
staples message appears. Install a new staple cartridge, or press
printing.

Moving the printer

Follow these guidelines to move the printer within the office or to prepare the printer for shipment.
CAUTION: Follow these guidelines to avoid injuring yourself or damaging the printer.
• Always use at least two people to lift the printer.
• Always turn off the printer using the power switch.
• Disconnect all cords and cables from the printer before attempting to move the printer.
• Failure to repackage the printer properly for shipment can result in damage to the printer not covered by the
printer warranty.
• Damage to the printer caused by improper moving is not covered by the printer warranty.
Moving the printer within the office
The printer can be safely moved from one location within an office to another following these precautions:
• The printer must remain in an upright position.
• Any cart used to move the printer should have a surface able to support the full footprint of the printer.
• Severe jarring movements may cause damage to the printer and must be avoided.
Preparing the printer for shipment
To transport the printer by vehicle or by commercial carrier, the printer must be repackaged for shipment using the proper
packaging. The printer package must be securely fastened to its pallet. Do not use a shipping or transport method that
requires the printer to be shipped without a pallet. The printer must stay upright throughout the shipment. If you do not have
all the original packaging, contact your local service representative to order the repackaging kit. Additional instructions for
repackaging the printer are provided in the repackaging kit.
Maintaining the printer
jams.
Moving the printer
77
to clear the message and continue