Chapter 3 Configuring From A Web Browser; Before Configuration - Eizo DuraVision FDF2304W-IP Installation Manual

Chapter 3
This product allows you to configure and operate network cameras from your web browser. Basic
Information, Monitor Settings, and the Live Image Screen Settings are located on the Web control screen.
Note
• To configure from the monitor screen, see
Attention
• It is recommended you use Internet Explorer 11 as your web browser.
• If you configure settings from a web browser, you will need to start up the monitor.
• You cannot display the web interface in your web browser when the monitor web interface is disabled in the settings
(For details, see "Communication Settings" (page
3-1. Before Configuration
To configure settings from a web browser, you need to log in from the web browser you are using. Login
is allowed only when the level of the user accessing the product is ADMIN.
Procedure
1. Press on the front of the monitor or
The power indicator lights up blue and the live image screen is displayed.
(For information on the live image screen, refer to the Instruction Manual.)
2. Display the web browser on your PC.
3. Enter the following address to access.
Address: http://Address of the monitors/ui
*1 The default address for access is http://192.168.0.150/ui.
The login screen is displayed.
4. Enter a username and a password.
5. Select "Login".
Displays the Web Control Screen.
Note
• The following user information is set by default:
- Username: "admin"
- Password: "admin"
- User Level: "ADMIN"
• For information on user settings, see
• It is recommended that you log out after completing the setup, so as to prevent a third party from operating
the network camera or altering the settings. Exit the web browser.
38

Chapter 3 Configuring from a Web Browser

Configuring from a Web Browser
"Chapter 2 Configuring from the monitor screen" (page
56)).
*1
"2-7. Setting User Information" (page
on the remote control.
34).
8).