Before You Call For Service - Fisher & Paykel DH9060FS User Manual

Heat pump clothes dryer
Hide thumbs Also See for DH9060FS:
Table of Contents

Advertisement

User warnings
Your dryer is capable of diagnosing a number of its own problems. It will sound a
continuous series of beeps and display a user prompt when it has a problem that you can
correct yourself. To stop the beeps sounding, touch any button on the control panel. Do not
try to continue your drying cycle once you stop the noise. You must address the problem
the dryer is alerting you to.
Check the below table before you call for service.
NOTIFICATION
KEYLOCK ON
CLEAN FILTERS AND
EVAPORATOR GRID
WATER TANK
DOOR OPEN
THE LAUNDRY
ENVIRONMENT IS
TOO COLD FOR
THE DRYER TO
FUNCTION
MAXIMUM CYCLE
TIME HAS BEEN
REACHED
Once you have addressed the issue the user prompt was alerting you to, try using your
dryer as per usual. If the issue persists, call your Fisher & Paykel trained and supported
service technician.
36

BEFORE YOU CALL FOR SERVICE

WHAT TO DO
Touch and hold the
the Keylock.
Clean lint and condenser filters and carefully vacuum the
evaporator grid.
Check the lint filter or condenser filter are not damaged.
Check there is nothing else trapped in the filters or evaporator grid,
which may be blocking the air flow.
Check the filters are correctly in place in your dryer.
Check if the water tank is full.
Empty the water tank.
If using the drain hose, check whether the water tank or drain hose
is blocked.
Check the drain hose is still attached at the back of the machine,
and is not kinked or squashed.
Close the door fully and touch
Try opening and closing the door again.
Reposition the load, make sure the load is correctly in the drum
and that protruding items are not preventing the door from closing.
The room temperature is too low for the heat pump system to work
effectively. Ensure that the room temperature is above five degrees to
avoid loss of efficiency.
There are a number of reasons the maximum cycle time has been
reached, refer to 'Troubleshooting', 'Dryer is taking too long.' for
possible causes and solutions.
button for three seconds to deactivate
.

Advertisement

Table of Contents
loading

Table of Contents