Before You Call For Service - Fisher & Paykel DE4024P1 Installation Instructions Manual

User warnings
Your dryer is capable of diagnosing a number of its own problems. It will sound a
continuous series of beeps and display a code when it has a problem that you can
correct yourself. All control panel lights will turn off and a code will be displayed to
inform you what the problem is. To stop the beeps sounding, press any button on the
control panel. Do not try to continue your drying cycle once you stop the noise, you
must address the problem the dryer is alerting you to.
Check this chart before you call for service.
PROBLEM
Keylock is
activated.
The lint filter
is blocked and
needs to be
emptied.
The water
tank is full and
needs to be
emptied.
The condenser
needs to be
cleaned.
The door is
not closed.
Once you have addressed the issue the user warning was alerting you to, try using your
dryer as per usual.
If the symptom persists, call your properly trained installer.
28

BEFORE YOU CALL FOR SERVICE

DISPLAYED AS WHAT TO DO
Touch and hold the
deactivate the Keylock.
Empty the lint filter and then replace it.
Check the lint filter is not damaged.
Check there is nothing else stuck in the lint filter
holder which may be blocking the air flow.
Check the lint filter is in place correctly in your dryer.
Check if the water tank is full.
Empty the water tank.
If using the drain hose, check whether the water tank
or drain hose is blocked.
Check the drain hose is still attached at the back of
the machine, and is not kinked or squashed.
Clean the condenser (refer to the 'Caring for your
dryer' section). Ensure the condenser unit has been
placed or replaced correctly into your dryer.
Close the door fully and touch
Try opening and closing the door again.
Reposition the load, make sure the load is correctly in
the drum and that protruding items are not stopping
the door from closing.
button for 2 seconds to
.