Yamaha DTX-PRO Owner's Manual page 69

Symptom
Having difficul- Sound is produced with-
ties during perfo- out striking the pad
mance
Sound is produced by a
pad that was not struck
(Crosstalk is occurring)
Cannot choke
Cannot mute
Foot closed hi-hat
sounds cannot be played
It is difficult to produce
closed hi-hat sounds
Pads with position sens-
ing do not produce
sounds properly
Settings The drum module does
not store its settings
Data cannot be saved on
a USB flash drive
Cannot send data to or
from the smart device
Power turns off unex-
pectedly
The DTX-PRO does not
receive any switch or
trigger signals at all
I want to reset the DTX-
PRO to the factory
default
Possible cause
For more information, refer to the "Refer-
ence Manual" (PDF).
Check the direction of the cymbal pad.
When the direction of the pad is improper,
the cymbal pad may not function fully.
• Make sure that you are fully and firmly
operating the hi-hat controller.
• Ensure that the foot controller is cor-
rectly connected to the [CONTROL]
jack.
• Ensure that the Pad Type parameter has
been set correctly. (For more informa-
tion, refer to the "Reference Manual"
(PDF).)
• Check the direction of the cymbal pad.
When this is not set properly, the cymbal
pad may not be fully functional.
• Make sure to use pads with position
sensing.
The drum module automatically stores its
system settings whenever you turn it off
using the [
• Do not turn off the drum module by
unplugging the AC adaptor. This will
prevent it from storing storing the sys-
tem settings.
• User settings for kits, click sets, and trig-
gers must be stored manually.
USB 1.1 compatible flash drives cannot
be used on the DTX-PRO.
• Ensure that the USB flash drive in ques-
tion has been formatted using the DTX-
PRO.
• Ensure that the USB flash drive in ques-
tion has not been write-protected.
• Ensure that there is sufficient free space
on the USB flash drive to save the data.
(For more information, refer to the "Ref-
erence Manual" (PDF).)
Check the connection. For more informa-
tion, refer to the iPhone/iPad Connection
Manual or Smart Device Connection
Manual for Android™.
Disable the Auto Power-Off function.
Use the Factory Reset to restore the set-
tings to the factory defaults.
Reference
Troubleshooting
Solution
] (Standby/On) button.
DTX-PRO Owner's Manual
Reference
page
Reference
Manual
(PDF)
page 24
Assembly
Manual
Assembly
Manual
page 24
Assembly
Manual
page 18
page 15
page 37
Reference
Manual
(PDF)
page 60
page 19
page 20
65