Exterior Loading; Merchandiser Ends; Shipping Braces; Leveling - Hussmann IMPACT D5RRI Operation And Service Manual
Rear roll-in dairy medium temperature free standing or suspended merchandisers installed in walk-in cooler exterior walls
Hide thumbs
Also See for IMPACT D5RRI:
- Technical data sheet (6 pages) ,
- Connecting (5 pages) ,
- Parts installation and removal manual (10 pages)
Table of Contents
Advertisement
I
1-2
NSTALLATION
CAUTION
!
Do not walk or put heavy objects on case.
EXTERIOR LOADING
Do NOT walk on top of merchandisers or
damage to the merchandisers and serious person-
al injury could occur. T
LY DESIGNED TO SUPPORT EXCESSIVE EXTERNAL
such as the weight of a person. Do not
LOADING
place heavy objects on the case.
MERCHANDISER ENDS
Ends for the D5RRI and D5RRIS rear load dairy
models are shipped separately to be field installed
after the cases are installed in the cooler wall.
Refer to separate instructions shipped with the
ends.
SHIPPING BRACES
Move the case as close as possible to its perma-
nent location and then remove all packaging.
Check for damage before discarding packaging.
Remove all separately packed accessories such as
kits and shelves.
WARNING
!
Do NOT remove shipping braces until
the merchandisers are positioned
for installation. Once unfastened,
NEVER LEAVE THE MERCHANDISER
UNSUPPORTED OR UNATTENDED
until it has been anchored.
P/N 0435045A
HEY ARE NOT STRUCTURAL
The D5RRI is top-heavy and must be supported
and moved with care at all times until it has been
securely anchored. It must be supported while it
is being unfastened from the skid and when it is
removed from the skid. Once the skid has been
unfastened, never leave the fixture unsupported or
unattended until it has been anchored.
LEVELING
-
Merchandisers must be installed level to ensure
proper operation of the refrigeration system and
to ensure proper drainage of defrost water. When
leveling merchandisers, use a carpenter's level as
shown. Leveling shims are provided with each
case for use if needed. The shims are big enough
so that you can level adjoining merchandisers at
the same time using one shim.
NOTES:
• B
EGIN LINEUP LEVELING FROM THE HIGHEST POINT
OF THE STORE FLOOR
• If shimming two corners, check to see if a shim is
needed in the center of the case. If a gap exists
between the support rail of the case and the floor, a
shim should be placed in the center.
.
Levels
Shim
.
WWW
HUSSMANN
.
COM
Advertisement
Table of Contents
