Fisher & Paykel RDV2 Installation Manual page 14

IMPORTANT!
Do not lift oven door by the handle – this will cause damage.
Be sure the oven and door are cool before you begin to remove the door.
1 Open the door completely.
1
1 Position the door in an approximately halfway open position.
2 Align the hinge tongue with the hinge slots.
3 Push the door into the slots until you feel the latches locate
into position on each side.
14
!1
TO REMOVE THE OVEN DOOR(S)
Hinge
2 Unlock the door hinges by rotating the lock forward.
!2
TO REFIT THE OVEN DOOR(S)
Hinge
Hinge
lock
tongue
Hinge
slot
2
3
4 Open the door completely and check that the hinges
are both secured by the correct notches as shown.
5 Rotate the locks into the closed position.
Lock
4
5
3 Once both hinges are unlocked, gently close the door
until approximately halfway closed. Grabbing the
sides of the door and gently lifting up and slightly
forward, the door will unlatch from the hinge.
4 Continue to lift and pull the door away from the
range.
6 Close the oven door.
IMPORTANT!
Hinge locks should rest inside the slots. Incorrect
installation will prevent door from correctly sealing.