Yamaha Apex RX10PA 2011 Supplementary Service Manual page 156

STEERING
4. Install:
• Tie rods
TIP
Make sure that the indentation
rod faces out.
NOTICE
• After tightening the inside and outside ball
joint locknut , make sure the tie rod
can be rotated freely through the ball joint
travel. If not, loosen the locknut
position the ball joint so that the tie rod
can be rotated freely.
Tighten the locknut to specification.
• Always use new cotter pins.
Tie rod end locknut:
25 Nm (2.5 m•kgf, 18 ft•lbf)
LOCTITE
Tie rod-idler arm nut:
30 Nm (3.0 m•kgf, 22 ft•lbf)
Tie rod-steering arm nut:
35 Nm (3.5 m•kgf, 25 ft•lbf)
60
CHAS
on the tie
and re-
®