Removing The Cisco M Sfs7000E Infiniband Switch; Connecting Infiniband Cables - Cisco M SFS7000E Installation Note

Removing the Cisco M SFS7000E InfiniBand Switch

To remove the Cisco M SFS7000E InfiniBand Switch, perform the following steps:
Step 1 Disconnect any cables attached to the Cisco M SFS7000E InfiniBand Switch.
Step 2 Press the release latch upward so the switch handle springs open partially.
Step 3 Rotate the switch handle all the way down to eject the switch.
Slide the switch out of the chassis bay.
Step 4
Install the I/O connector cover on the switch.
Step 5
When you remove a switch, you must either replace it with an identical switch or a blank IOM within
Note
one minute of removal.

Connecting InfiniBand Cables

This section describes briefly how to connect your IB cables.
Use IB cables to connect your Cisco M SFS7000E InfiniBand Switch. To plug in an IB cable, push the
connector into the interface. For the pull connector, push the latch until it is engaged after it is in the
interface. An alternative method to plug in a pull connector IB cable is to push the latch first, and then
insert the connector until you hear a click. (See
Figure 7
78-18371-01
InfiniBand Cable with Pinch Connector
Cisco M SFS7000E Installation Note: InfiniBand Blade Switch for the Dell Modular Server Chassis
Removing the Cisco M SFS7000E InfiniBand Switch
Figure 7 and Figure 8.)
11