Fisher & Paykel WashSmart Eco Installation Instructions & User Manual page 46

PROBLEM
The washer
is out of
balance.
The washer
has too many
suds.
The lid can't
lock or the lid
is open.
The washer is
overloaded.
The washer
has stopped.
The washer
has stopped.
The washer
is on but the
display is
blank.
* The beeps are the same sound your washer makes when you turn it on at the wall.
44
BEFORE YOU CALL FOR SERVICE
DISPLAYED AS WHAT TO DO
Wash load is out of balance. Ensure the washer is
stationary. Manually redistribute the load.
Check the washer is level. (Refer to 'Installation
instructions – Levelling instructions' for more
information).
The washer has a suds build-up (too much detergent
may have been used for the amount of soil in the
load). Wait for suds to dissolve (about 20 min). Rinse
clothes using a deep rinse.
Check the standpipe height does not exceed 1200 mm.
If the symptom persists, call your Fisher & Paykel
dealer or Fisher & Paykel trained and supported
service technician.
Make sure the lid is closed.
Touch
for more information).
If the symptom persists call your Fisher & Paykel
dealer or Fisher & Paykel trained and supported
service technician.
The washer is overloaded and can not agitate. Ensure
the washer is stationary. Remove items until the
remaining ones can move freely.
Select a higher water level.
The power was cut to the washer. The washer will
restart automatically. No action is required.
The
washer was inactive for 3 minutes. The washer will
automatically drain to a safe level. Touch any button
to stop autodraining then touch
wash cycle.
The washer was unattended without starting a cycle
for a period of time. Touch 'POWER'
. (Refer to 'Washer safety features – Lid lock'
or 'POWER' button was touched and the
to resume the
to activate.