Fisher & Paykel WashSmart Eco Installation Instructions & User Manual page 39

Controlled Cold (not available on QuickSmart™ washer)
If the temperature of your cold water supply is very low and you choose to do a
'Cold' wash, you will not get an effective wash. The 'Controlled Cold' option solves this
problem by adding a small amount of hot water to raise the temperature of the wash
to approximately 20°C.
Enter Option Adjustment mode (refer to page 34).
1
Select the 'Regular' cycle.
2
Select 'Cold' wash temperature by touching the 'Wash Temp' button (if not already
3
selected).
The digital display shows the temperature adjustment possible. The default setting
4
is , which is the same temperature as the incoming water from the supply for
cold water.
To get 'Controlled Cold', touch the 'More'
5
will now adjust the cold temperature to approximately 20°C. Each of the remaining
settings equals an approximate 1.0°C temperature increase or decrease from this point
(excluding
Touch 'POWER'
6
Wash
Temp
WashSmart™ Eco washer and WashSmart™ washer (WashSmart™ Eco washer panel is shown)
Changing the cold wash temperature setting from cold tap to 'Controlled Cold'
Note: if you always use 'Cold' or Controlled Cold' water, we recommend that a 'Warm'
or 'Hot' wash be used regularly, eg every 5th wash should be at least a warm one. Warm
water is needed to help maintain the cleanliness of your washer.
CHANGING PRE-SET OPTIONS
).
to save the setting (if you wish to make no other changes).
button until is displayed. Your washer
Wash
Temp
37