Installation And Operating Instructions; Checks Before Installation; How To Remove Panels - Hoshizaki KML-450MAF Instruction Manual

II. INSTALLATION AND OPERATING INSTRUCTIONS

1. CHECKS BEFORE INSTALLATION

Remove shipping carton, tape(s) and packing. If packing material is left in the
icemaker, it will not work properly.
1) Remove the panels to prevent damage when installing the icemaker. See "2. HOW TO
REMOVE PANELS."
2) Remove the package containing the accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the sun
or to heat, remove the film after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade turns freely.
5) Check that the Compressor is snug on all mounting pads.
6) See the Nameplate on the Rear Panel, and check that your voltage supplied corresponds
with the voltage specified on the Nameplate.
7) This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE
STORAGE BIN, Model B-500 series, DB-200, or DM-180 series.
2. HOW TO REMOVE PANELS - See Fig. 1
a) Front Panel ......... Remove the screw.
b) Top Panel ............ Lift its front up slightly,
c) Side Panel (R) ..... Remove the screw.
d) Insulation Panel .. Lift up slightly, and pull
IMPORTANT
Lift up and pull toward
you.
push away, and then lift
off.
Pull slightly toward you,
and lift off.
toward you.
8
Fig. 1
A1BC10A9904 A1BC10A9901