Installation And Operating Instructions; Checks Before Installation; How To Remove Panels - Hoshizaki DCM-750BAH Instruction Manual

II. Installation and Operating Instructions
A. Checks Before Installation
1. Install in accordance with all applicable national, state, and local regulations.
. Remove the shipping carton, tape, and packing material. If any are left in the
icemaker, it will not work properly.
3. Ensure all components, fasteners, and thumbscrews are securely in place
after installation.
1) Remove the panels to prevent damage when installing the icemaker. See "II.B. How to
Remove Panels."
) Remove the package containing the accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
5) Check that the compressor is snug on all mounting pads.
6) See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
7) This icemaker can be installed on a countertop or optional stand. If using an optional
stand, the recommended stands are HOSHIZAKI STAND SD-700 or SD-750.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and towards you.
• Top Panel: Remove the thumbscrew. Lift up at front slightly, push rearward and lift off.
• Apron Panel: Remove the screws and pull towards you.
• Side Panel: Remove the screws and pull towards you.
Fig. 1
IMPORTANT
Side Panel
Front Panel
Apron Panel
13
Top Panel
Side Panel