Final Checklist - Hoshizaki DCM-750BAH Instruction Manual

G. Final Checklist
1) Is the icemaker level?
) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F
(+7°C to +38°C) and the water temperature within +45°F to +90°F (+7°C to +3°C) all
year around?
3) Is there at least 6" (15 cm) clearance at rear and sides and 4" (61 cm) at top for proper
air circulation and maintenance or service?
4) Have the shipping carton, tape, and packing material been removed from the
icemaker?
5) Are all components, fasteners, and thumbscrews securely in place?
6) If the icemaker is on a stand, has it been secured to the stand as outlined in the
stand's installation instructions? If the icemaker is mounted flat to a counter, has the
perimeter where the icemaker contacts the counter been sealed with approved caulk
compound?
7) Have all electrical and water connections been made?
8) Has the power supply voltage been checked or tested against the nameplate rating?
Has a proper ground been installed to the icemaker?
9) Are the water supply line shut-off valve and drain valve installed? Has the water
supply pressure been checked to ensure a minimum of 10 PSIG and a maximum of
113 PSIG?
Note: The icemaker may stop running when the water supply is off, or if the pressure
is below 10 PSIG. When the proper water pressure is reached, the icemaker
automatically starts running again.
10) Are the compressor hold-down bolts snug? Have the refrigerant lines been checked to
make sure they do not rub or touch other lines or surfaces?
11) Has the bin control switch been checked for correct operation? To check, push and
hold the actuator paddle located inside the storage bin. The compressor should stop
90 seconds later, and the gear motor 60 seconds after that.
1) Has the end user been given the instruction manual, and instructed on how to operate
the icemaker and the importance of the recommended periodic maintenance?
13) Has the end user been given the name and telephone number of an authorized service
agent?
14) Has the warranty card been filled out and forwarded to the factory for warranty
registration?
18