Dyna-Glo SEARPLUS DGF481CRN Assembly Instructions Manual page 20

Operation Instructions - cont.
Lighting The Grill
Before first use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
and the control knobs in the highest position. This will clean the internal parts by burning off any residue
and odor from the manufacturing process.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF
the natural gas shut-off valve and then TURN OFF the control knob.
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO PREVENT
FIRE, DAMAGE AND/OR INJURY.
Do not lean over grill when lighting. Read instructions before lighting.
1. Check that the control knobs are in the O OFF position.
2. Open natural gas supply at shut-off valve.
3. Open lid during lighting.
4. Depress and turn control knob counterclockwise
position, to the high position for the main burners and
to repeat several times to ignite the burner.
If ignition does not occur in 5 seconds, turn the control knobs to
repeat the lighting procedure.
If the burner still does not light, check that there is gas in the cylinder and follow the match lighting
instructions on the following page.
Cooking:
After lighting, adjust burner, including SearPLUS™ burner, from high (
cooking temperature.
Searing Food with the SearPLUS™ Burner:
To sear food, use the SearPLUS™ burner with the red control knob, which has a higher temperature
range than the other burners. After lighting, adjust SearPLUS™ burner control knob to Sear Position
( ) and place food to be seared on the sear grate directly over the SearPLUS™ burner.
Normal High Normal Low
Regular Control Knob
CAUTION
WARNING
from O OFF position, past the
for the SearPLUS™ burner. You may need
SearPLUS™ Control Knob
Sear Normal High Normal Low
20
O OFF position, wait 5 minutes, and
) to low ( ) position for desired
ignite