Dyna-Glo SEARPLUS DGF481CRN Assembly Instructions Manual page 19

Operation Instructions - cont.
CHECKING FOR LEAKS
After all connections are made, check all connections and fittings on the natural gas quick connector,
gas hose and manifold for leaks with a water and soap solution.
Always perform leak test prior to lighting the grill.
Do not smoke while testing for a leak.
Always perform leak tests outdoors in a well-ventilated area.
Do not use any source of flame while testing for leaks.
Do not use the grill until any and all leaks are corrected.
If you are unable to correct a leak, disconnect the propane supply and call a gas appliance service
dealer.
PERFORM LEAK TEST
Prepare leak test solution by 50/50 ratio of liquid dish soap and water.
Put leak test solution in a spray bottle.
Ensure all control knobs are in the
Connect the gas hose to the gas supply.
Open the gas shut-off valve.
Spray leak test solution on all gas carrying connections and fittings. Presence of bubbles at areas
of applied test solution indicates a gas leak. If leaks are detected or you smell or hear gas, shut off
the gas supply valve immediately and repair or replace the defective part. Do not use the grill until
all leaks are corrected.
ONLY USE THE HOSE ASSEMBLY PROVIDED! IF A REPLACEMENT IS NECESSARY, PLEASE
CALL OUR CUSTOMER SERVICE CENTER. DO NOT USE REPLACEMENT PARTS THAT ARE
NOT INTENDED FOR THIS GRILL.
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO
PREVENT FIRE, DAMAGE AND/OR INJURY.
O
OFF position.
CAUTION
WARNING
19