7.1.2 DISASSEMBLY
Notes: (Disassembly and assembly)
- Two bending projections are provided on the right side of the product and one bending projections
are provided on the back side of the product. Handle with care during assembly/disassembly.
- Wire arrangement when connecting the 2-Pin cable
After connecting the 2-pin cable (to the CD mechanism) on the mother board, arrange the cable as shown
below:
Bend the 2 clampers leftwards to secure the cable as shown in fig.a.
DSP
SHILD
Set the cable on the left side of these two clampers.
fig.a
FH-P6600R,P6600
87