FoodSaver FM2900 Owner's Manual page 5

How to...
2. Vacuum Seal with FoodSaver
1. Place item(s) in bag, allowing at least three inches
(7.62 cm) of space between bag contents and top
of bag.
2. Open appliance lid and place open end of bag into
Vacuum Channel (Drip Tray).
3. Close lid and turn Easy Lock Latch to
OPERATE position.
4. Press Vacuum button to begin vacuum and sealing
process. Motor will continue to run until bag is fully
vacuumed, then will automatically seal.
5. When Seal Indicator Light turns off, turn Latch to
OPEN position, lift lid and remove bag. Refrigerate,
freeze or store as needed. (See FoodSaver
Guidelines, pg E7 for safe food storage tips.)
Important Tips:
• Let appliance cool down for 20 seconds after
each use. Always store appliance with the Easy
Lock Latch in the center STORE position.
• To minimize bag waste, do not insert too much
bag material into removable drip tray. Place bag
just over the edge of removable drip tray.
E5 www.FoodSaver.com
FM2900_21EFSM2.indd 5-6 FM2900_21EFSM2.indd 5-6
Bags
®
Place Bag in Drip Tray
Operate
Store
Open
®
Close and Latch Lid
Press Vacuum Button
How to...
3. Vacuum Seal with FoodSaver
Installing Handheld Sealer
1. Remove the plastic plug on the left side of the appliance by
lifting it up from the side with hand. If necessary, use a small
dull object to pop it up by pressing down and up on side.
Save plug only if you do not want to clip the handheld into the side
of appliance.
2. Insert Chamber Clip into the hole until it clicks into place.
Zipper Bags and Containers
(not included; sold separately)
1. Prepare container or zipper bags according to FoodSaver
Accessory Guidelines, which are included with accessory
purchases. For zipper bags, make sure not to put any food under
the valve and press zipper closed with finger while bag is lying
down on a flat surface.
2. Close FM2900 lid and turn Easy Lock Latch to OPERATE position.
Insert one end of the Accessory Hose into Accessory Port on
appliance until it clicks into place. Place end over valve on
container (a) or zipper bag (b) valve.
3. Push Vacuum Button to begin vacuum process. Make sure it is
in the Dry Mode setting. Motor will run until vacuum process is
complete.
Canisters, Jar Sealers, & Bottle Stoppers
1. Prepare canister according to FoodSaver ® Accessory Guidelines, which are
included with accessory purchases.
2. Close FM2900 lid and turn Easy Lock Latch to OPERATE position. Insert one
end of the Accessory Hose into Accessory Port on appliance until it clicks
into place. Remove clear bottom portion of handheld from top handle (Fig. 1).
Insert the end into the port on accessory. Twist tab while inserting to ensure
a tight fit.
3. Push Vacuum Button to begin vacuum process. Make sure it is in the Dry
Mode setting. Motor will run until vacuum process is complete.
4. When motor turns off, gently twist and remove Handheld Sealer from
accessory.
NOTE: If you are using a canister with a large white knob, rotate knob clockwise
to the "Closed" position, then gently twist and remove Handheld Sealer from
accessory.
5. To test vacuum, simply tug on accessory lid. It should not move.
NOTE: FoodSaver Jar Sealers are for use with Ball and Kerr brand Mason jars
only
Customer Service: 1 (877) 777-8042
Accessories
®
®
B
A
(not included; sold separately)
Fig. 1
2021/11/12 上午11:05 2021/11/12 上午11:05
E6