Table of Contents
Advertisement
VARIOUS FUNCTIONS
Set the condensation prevention heater to MIN.
Setting the condensation prevention heater to MIN saves energy.
When dew is formed in the swing partition, set it to the standard.
The temperature settings for the swing partition can be adjusted by three levels (1 to 2), and level 2 is the most energy saving.
MIN setting of the heater
Preset sound
Setting the swing partition
1
Open the door of the Lower Freezer Compartment.
2
Press down
Settings of condensation prevention heater will be changed. Repeat the change of settings to set the operation sound you like
(See the table shown above).
3
Close the door of the Lower Freezer Compartment.
Notice
● The setting will be returned to the standard when the power plug is disconnected and connected or power failure recovery takes place.
Fine adjustment of the temperature
Temperature settings for Refrigerator and Freezer Compartments can be more finely adjusted by 11 levels.
1
Open the door of the Lower
Freezer Compartment.
2
Press down
seconds or more until 1 beep is
heard.
3
Close the door of the Lower
Freezer Compartment.
Triple Power Deodorizing Effect
A combination of 3 types of deodorizing materials leads to deodorizing various odorous substances in the refrigerator including 4
major odors such as sulfur, nitrogen, aldehyde and oxidization odors. Activities of bacteria collected by the filter are also restricted.
Deodorant filter has the effect of sterile filtration.
● Testing laboratory: Boken Quality Evaluation Institute, a general incorporate foundation ● Test method: Film contacting method (JIS Z 2801)
● Name of the part used for treatment: Filter ● Sterilization method: applying oxidation catalyst to the filter ● Target: bacteria collected by the filter
● Test result: sterilization effect of 99 % after 24 hours by using a filter only. This does not always have effect on the entire refrigerator or foods.
56
MIN setting
Standard
level 1
−
Long beep
(Factory setting)
button 3 seconds or more until the preset sound is heard.
button for 5
(CONTINUED)
(Swing partition)
MIN setting
Standard
level 2
Long beep (2 beeps)
2 beeps
(Refrigerator Compartment / Freezer Compartment)
4
Push
adjustment.
Each time you touch the button, the corresponding indicator lamp
changes in the order shown below.
Usually it is recommended to use it at the setting of " ■■ " .
(
Lighting
Blinking
Indication
lamp
Setting
MI N and under MIN.
Follow the operations shown in Step 1, 2 and 3.
2 beeps sound and you can set the temperature by normal step (3 levels).
Swing partition
or
button to make an
Turned off )
MID.
MAX. MAX and more
Advertisement
Chapters
Table of Contents
