Table of Contents
Advertisement
Safety instructions
Injury or material damage
You risk the development of danger sources and deactivation of safety functions if you
neglect the safety and handling instructions provided in this document. This can result in
personal injuries or material damage.
Strictly adhere to the safety and handling instructions.
Always adhere to the safety instructions and accident prevention regulations for the
respective application, independent of the safety instructions provided in this document.
Safety in the project
Injury or material damage
The configuration engineer for a plant controller must take appropriate measures to ensure
the proper restart of an interrupted program after a voltage dip or power failure.
Dangerous operating states may not develop at any time during runtime of the program and
during troubleshooting.
Safety during commissioning and operation
Note
It is strictly prohibited to commission the carrier controller unless compliance with Machinery
Directive 2006/42/EC has been verified for the EMS in which the carrier controller is being
operated. Verify that all requirements of the machinery directive have been met before you
start commissioning.
Observe the relevant safety guidelines when using the EMS400S carrier controller in an
EMS. Detailed information on this topic is available in the section "Safety instructions" in the
"EMS400S Plant controller for Electric Monorail Systems" system manual.
The documents belonging to the EMS400S plant controller are listed in the preface.
Carrier controller
Operating Instructions, 09/2013, A5E03474162-02
WARNING
WARNING
3
15
Advertisement
Table of Contents
