Adaptor Installation - Mazda MAZ-95-130-KT Operation Manual

Safety Warnings:
• The maximum test pressure a Power INTAKE
• Slippage of a Power INTAKE
Intake / Exhaust system, coefficient of friction, internal pressure of the Power INTAKE
accuracy of inflation instruments.
• Generally, a Power INTAKE
slipping when test pressure exceeds 50% of the internal inflation pressure. Inflation pressure and back
pressure limitations are subject to temperature / humidity change.
• Power INTAKE Adaptor should NEVER be inflated over 1.6 times its outside diameter.
™
• Debris, protrusions and residue in the Intake / Exhaust system could weaken and / or rupture the
bladder of the Power INTAKE
warranty. Redline Detection shall not be responsible for any incidental or consequential damages.
• Power INTAKE Adaptor must be mechanically anchored with the provided chain / cable to a secure
™
location before use.
• Power INTAKE Adaptor slippage under test pressures may cause property damage or injury.
™
• NEVER use inflation pressure with Power INTAKE
capacity of the weakest component in the system under test.
• NEVER use Power INTAKE
• Before use: Refer to Power INTAKE
limitations and tether restraint installation instructions.
Installing Power INTAKE
1. Install Power INTAKE
™
are no obstructions or sharp edges that might puncture bladder when inflated. Power INTAKE
must insert completely inside ducting / tubing.
2. Install safety chain / cable to a secure location.
3. Inflate Power INTAKE
™
release. If release occurs, reinflate to 30 PSI (2 BAR).
4. Firmly tug on safety chain to insure Power INTAKE
5. Attach vapor hose for testing.
Proper Installation
Removal of Power INTAKE
1. Remove vapor hose (or block off adaptor) at quick coupler to deflate tested system
2. ONLY AFTER system under test is fully depressurized, release internal pressure of Power INTAKE
slowly by depressing Schrader valve
3. Detach safety chain / cable
4. Remove Power INTAKE
POWER INTAKE
Adaptor may restrain can only be estimated.
™
Adaptor is influenced by many factors including debris / residue in the
™
Adaptor properly inserted into an Intake / Exhaust system may begin
™
Adaptor. Bladder failures due to misuse or abuse are not covered by
™
Adaptor when its failure could cause injury or catastrophic damage.
™
Adaptor Installation and Inflation procedures, back pressure
™
Adaptor:
™
Adaptor fully into intake system ductwork or exhaust tubing. Make sure there
Adaptor to 30 PSI (2 BAR) maximum. If over inflated, pop off safety valve may
Adaptor:
™
Adaptor from ductwork, making sure not to rub across sharp edges
™
ADAPTOR USAGE
™
Adaptor or a test pressure that is greater than the
™
Adaptor is firmly installed and properly secure.
™
Improper Installation
Adaptor, and the
™
Adaptor
™
™
7
EN