Table of Contents
Advertisement
USING THE UNIT SAFELY
WARNING
Concerning the Auto Off function
The power to this unit will be turned off automatically
after a predetermined amount of time has passed
since it was last used for playing music, or its buttons
or controls were operated (Auto Off function). If you do
not want the power to be turned off automatically, disengage
the Auto Off function (p. 5).
Secure a sufficient amount of space at the setup location
Since this unit normally emits a slight amount of heat,
make sure to secure sufficient space around it, as
shown below.
Rear
30 cm (12 in.)
5 cm (2 in.) or
or greater
greater
20 cm (8 in.) or greater
20 cm (8 in.) or greater
IMPORTANT NOTES
Power Supply
¹ Place the AC adaptor so the side with the indicator faces
upwards. The indicator will light when you plug the AC
adaptor into an AC outlet.
Placement
¹ Depending on the material and temperature of the surface
on which you place the unit, its rubber feet may discolor or
mar the surface.
Repairs and Data
¹ Before sending the unit away for repairs, be sure to make
a backup of the data stored within it; or you may prefer to
write down the needed information. Although we will do
our utmost to preserve the data stored in your unit when we
carry out repairs, in some cases, such as when the memory
section is physically damaged, restoration of the stored
content may be impossible. Roland assumes no liability
concerning the restoration of any stored content that has
been lost.
About the Internal Battery
¹ The time is stored and maintained in this unit even when the
power is turned off. If the internal battery loses power, the
following message is shown on the display.
Battery Error!
Please contact our services.
If you see the message "Battery Error!", contact a Roland
service center or an official Roland dealer for service.
For a list of Roland service centers and official Roland dealers,
refer to the Roland website.
8
Use only the supplied AC adaptor and the correct voltage
Be sure to use only the AC adaptor supplied with the
unit. Also, make sure the line voltage at the installation
matches the input voltage specified on the AC
adaptor's body. Other AC adaptors may use a different
polarity, or be designed for a different voltage, so their use
could result in damage, malfunction, or electric shock.
Use only the supplied power cord
Use only the attached power cord. Also, the supplied
power cord must not be used with any other device.
Side
Handle lithium batteries carefully
¹ Lithium batteries must never be recharged, heated,
15 cm (6 in.) or
taken apart, or thrown into a fire or water.
greater
¹ Keep lithium batteries out of reach of small children.
If a child has accidentally swallowed a battery, see a
doctor immediately.
¹ Never expose lithium batteries to excessive heat
such as sunshine, fire or the like.
Additional Precautions
¹ Any data stored within the unit can be lost as the result
of equipment failure, incorrect operation, etc. To protect
yourself against the irretrievable loss of data, be sure to make
a backup of the data stored within it; or you may prefer to
write down the needed information.
¹ The manufacturer accepts no responsibility for recovery of
stored content that might be lost, including video or audio
data, nor for compensation of any such loss.
¹ Never strike or apply strong pressure to the display.
¹ This unit allows you to switch images at high speed. For some
people, viewing such images can cause headache, nausea,
or other discomfort. Do not use this unit to create video
that might cause these types of health problems. Roland
Corporation will accept no responsibility for any such health
problems that may occur in yourself or in viewers.
¹ Do not use connection cables that contain a built-in resistor.
¹ This unit cannot be used to directly connect to a network
operated by a telecommunications provider (such as a mobile
or landline-based telecommunications company, an Internet
provider or the likes), including a public wireless LAN. You
must use a router or similar equipment when connecting this
unit to the Internet.
Using External Memories
¹ Please observe the following precautions when handling
external memory devices. Also, make sure to carefully
observe all the precautions that were supplied with the
external memory device.
– Do not remove the device while reading/writing is in
progress.
– To prevent damage from static electricity, discharge all
static electricity from your person before handling the
device.
WARNING
CAUTION
Handle the ground terminal carefully
If you remove the screw from the ground terminal, be
sure to replace it; don't leave it lying around where
it could accidentally be swallowed by small children.
When refastening the screw, make that it is firmly
fastened, so it won't come loose.
Precautions concerning use of phantom power supply
Always turn the phantom power off when connecting
any device other than condenser microphones that
require phantom power. You risk causing damage if
you mistakenly supply phantom power to dynamic
microphones, audio playback devices, or other devices that
don't require such power. Be sure to check the specifications of
any microphone you intend to use by referring to the manual
that came with it.
(This instrument's phantom power: 48 V DC, 10 mA Max)
Intellectual Property Right
¹ It is forbidden by law to make an audio recording, video
recording, copy or revision of a third party's copyrighted work
(musical work, video work, broadcast, live performance, or
other work), whether in whole or in part, and distribute, sell,
lease, perform or broadcast it without the permission of the
copyright owner.
¹ Do not use this product for purposes that could infringe on a
copyright held by a third party. We assume no responsibility
whatsoever with regard to any infringements of third-party
copyrights arising through your use of this product.
¹ The copyright of content in this product (the sound
waveform data, style data, accompaniment patterns, phrase
data, audio loops and image data) is reserved by Roland
Corporation.
¹ Purchasers of this product are permitted to utilize said
content (except song data such as Demo Songs) for the
creating, performing, recording and distributing original
musical works.
¹ Purchasers of this product are NOT permitted to extract
said content in original or modified form, for the purpose
of distributing recorded medium of said content or making
them available on a computer network.
¹ The SDXC logo
is trademark of SD-3C, LLC.
¹ This product is using the open source license (GPL/LGPL)
software. You have the right to acquire, modify and distribute
the source code for this open source license software. You
can obtain the open source license source code used in this
product by downloading it from the following website:
https://proav.roland.com/global/support/
¹ This product contains eParts integrated software platform of
eSOL Co.,Ltd. eParts is a trademark of eSOL Co., Ltd. in Japan.
¹ This product uses software that is covered by the MIT license.
For details, refer to the following manufacturer website:
https://proav.roland.com/global/support/
¹ Roland is an either registered trademark or trademark
of Roland Corporation in the United States and/or other
countries.
¹ Company names and product names appearing in this
document are registered trademarks or trademarks of their
respective owners.
Advertisement
Table of Contents
