Related Manuals for Costway HW64404
Summary of Contents for Costway HW64404
- Page 1 USER'S MANUAL 3 Pcs Wicker Set HW64404 THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE...
-
Page 2: Before You Start
Contact Us! Do NOT return this item. Contact our friendly customer service department for help first. Before You Start 心 Read each step carefully before starting. It is very important to ensure each step followed in 多 correct order, otherwise assembly difficulties may occur. 心... -
Page 3: Board Identification
Board Identification Not actual size Right Arm x 2 Left Arm x 2 Seat and Back Combination x 2 Cross Bar x 2... - Page 4 Board Identification Not actual size...
-
Page 5: Hardware List
Hardware List Actual size 、 勹 ＇， 置霉） 狐霾圆圆劂 M6 x 15mm M6 x 30mm 二 ＼ BOLT BOLT - 、 } _ 1 1 1 拿酬归 』 � ® M6 x 35mm 勹 ＠ 勹 ＼ WASHER BOLT 、 ·... - Page 6 STEP 1 Insert adjustable levellers(」) to bottom of each Arm (A) by turning clockwise until secure. Adjust height as desired. Repeat step for the other side arm(B).
- Page 7 STEP 2 Attach the Seat and B ack Combination(C)to the arm (A&B) by inserting bolts (G) with washers (H). IMPORTANT:Do not tighten completely until assembly is completed.
- Page 8 STEP3 Attach the cross bar(D) to the arm (A&B)by bolts (E) with washers (H).Attach the cross bar(D) to the Seat and back combination(C)by bolts(F) with washers (H) . STEP4 Tighten all the bolts with the wrench, and turn the chair to the upright position. Your chair is now ready for use.
-
Page 9: Maximum Loads
Maximum Loads I � 了 二 二 芯 :: 二 二 二 ： 言 :�� �= lo a ds tha n 言 : u:... - Page 10 Board Identification Not actual size Table Top x 1 Table Leg x 3...
- Page 11 Board Identification Not actual size � 乏...
- Page 12 Hardware List Actual size 、 。 『 信 付 M6 x 3 0mm 丿 [ ® BOLT ALLEN WRENCH 『 亡 皿 ， ＇ 寸 _一 二' 丿 ＠厂” ADJUSTABLE WASHER LEVELLERS...
- Page 13 STEP 1 Insert adjustable levellers(J) to bottom of each Leg (L) by turning clockwise until secure. Adjust height as desired. J - -- - --- --- , "...
- Page 15 STEP 3 Attach the glass(K)to the table leg (L) by inserting bolts {M) with washers (H). STEP4 Tighten all the bolts with the allen wrench, and turn the table to the upright position. Your table is now ready for use.
- Page 16 Maximum Loads 竺��; 型竺 l o ads 二 ;:::i�7� 盂 己芯立；:�;-�� �� �...