Page 1
Please give us a chance to make it right and do better! FLOOR AREA 2MX2M Contact our friendly customer service department for help first. Replacements for missing or damaged parts will be shipped ASAP! Follow Costway ASSEMBLED BY 2 ADULTS...
E-mail US: cs.us@costway.com UK: cs.uk@costway.com Before You Start Read each step carefully before starting. It is very important to ensure each step followed in correct order, otherwise assembly difficulties may occur. Most of board parts are labeled or stamped on the raw edges. Have a check to make sure all parts are included.
Page 3
Not actual size Left Arm x 2 Right Arm x 2 Back x 2 Seat x 2...
Hardware List Actual size M6 x 35mm BOLT WASHER 4 x 4 ALLEN WRENCH...
Page 6
STEP 1 Attach the seat(D) to the arm (B) by inserting bolts (J)with washers (K) through the pre-drilled holes on the seat into the pre-welded nuts on the arm. Repeat step for the other side arm(A). assembly is completed.
Page 7
STEP 2 Attached the back(C) to the arm (A&B) by inserting bolts (J) with washers (K).
Page 8
STEP 3 Tighten all the bolts with the allen wrench, and turn the chair to the upright position. Your chair is now ready for use.
Maximum Loads 250 lbs This item is only suitable within the specified maximum load-bearing. Heavier loads than the indicated load capacity may cause instability, resulting in possible injuries.
Page 10
Not actual size Table Top x 1 Table Leg x 4 Resin Shelf x 1...
Page 12
Hardware List Actual size M6 x 10mm M6 x 15mm BOLT BOLT 4 x 4 ALLEN WRENCH WASHER...
Page 13
STEP 1 Attached the leg(F) to the table top (E) by inserting bolts (H) with washers (K). IMPORTANT:Do not tighten completely until assembly is completed.
Page 14
STEP 2 Attached the leg(F) to the resin shelf (G) by inserting bolts (I) with washers (K).
Page 15
STEP 5 Tighten all the bolts with the allen wrench, and turn the table to the upright position. Your table is now ready for use.
Page 16
Maximum Loads 25 lbs This item is only suitable within the specified maximum load-bearing. Heavier loads than the indicated load capacity may cause instability, resulting in possible injuries.
Care and Maintenance Use a soft, clean cloth that will not scratch the surface when dusting. Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area. Using solvents of any kind on your furniture may damage the finish. Never use water to clean your furniture as it may cause damage to the finish.
Page 18
Reward Points Exclusive Customer Service Permanent Shopping Cart Order History...