Wire Management Drawing 1.2. NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical compo- nent or electrical enclosure, the vacuum cleaner should be reassembled and checked for dielectric breakdown or current leak- age.
2.3. Packing Material 2.3.1. Exploded View 2.3.2. Parts List Ref. No. Part No. Part Name & Description Quantity Remarks AC61ZCWZZ0E0 Packaging Assembly Includes 1 and items A-J AC01ZCWZZ0E0 Operating Instructions...
3 REPLACEMENT INSTRUCTIONS 3.1. Dust Cover 3. Remove the two (2) cord stopper screws, the wire con- nectors, and wire tie, if present. 3.1.1. Removal 3.2.2. Installation 1. Remove dust bin. 1. Insert the mains lead (mains lead replacement only) with 2.
3.5. Nozzle Housing Replacement place. 2. Reinstall body support. 3.5.1. Removal 3. Reinstall dust cover as outlined in Dust Cover Removal and Replacement section. 1. Press handle release pedal. Lay vacuum cleaner back on NOTE: For general servicing, it is necessary to eliminate pinch- a flat surface.
3.5.2. Installation 3.6.2. Installation 1. Fit the nozzle from the motor shaft side first, and rotate it 1. Reinstall lower plate by hooking front end of lower plate into place on the dust container. into slots on front of nozzle housing. 2.
3.8. Belt Replacement 3.8.2. Installation 1. Loop new belt around motor shaft and brush pulley; see 3.8.1. Removal illustration for correct belt routing. 1. Place carpet-bare floor selector in CARPET position. 2. Remove lower plate as outlined in the LOWER PLATE REPLACEMENT section.
3.9. Carpet/Bare Floor Selector cover as outlined earlier in this manual. Replacement 3.9.1. Removal 1. Place the carpet-bare floor pedal in the carpet position. Insert a screwdriver under the back of the pedal cover and pry up to remove it from the pedal assembly. Take care not to scratch the nozzle housing.