Cleaning And Maintenance; Troubleshooting - Dometic Ace AIR Pro Operating Manual

Only Ace AIR PRO 500 made before January 2022:
5. Inflate the additional air pole.
6. Fix the inflated air pole into place in the middle
back roof panel using the velcro fasteners.
You find the production data on the label next to
the fire regulation label inside the back of the
awning.
Dismantling the awning tent
A
NOTICE! Damage hazard
Do not use force when dismantling the
awning tent. Otherwise you might dam-
age any material.
1. Remove any dirt on the outside.
2. Close all window blinds or remove curtains.
3. Close all doors and openings.
4. If installed, push the canopy pole out of the
sleeve, do not pull.
5. Remove all lines and straps.
6. Remove all pegs between the corner pegs.
7. Open the valves on each pole.
8. Wait until most of the air has been expelled.
9. Remove the four corner pegs.
10. Fold/roll the awning tent towards the valves to
expel more air.
11. When deflated, roll the awning tent to fit into
the carry bag.
12. Ensure that all parts are clean before packing
them into the carry bag.
13. If the awning tent is wet or damp, dry fully as
soon as possible.

Cleaning and maintenance

A
NOTICE! Material damage
• Do not use sharp or hard objects or
cleaning agents for cleaning.
• Do not use alcohol based materials,
chemicals, soap and detergents for
cleaning.
• Remove bird droppings and tree resin
as soon as possible to avoid perma-
nent damage to the material.
1. If necessary, clean the product with clean
water and a soft brush.
2. Apply impregnation against water and UV
radiation before each trip.
Storing the awning tent
I
NOTE
• Fully set up the awning tent for clean-
• Choose a sunny day for cleaning to
1. Clean the awning tent.
2. Air fully and ensure the awning tent is totally
dry before packing away.
3. Store in a well ventilated dry place.

Troubleshooting

I
NOTE
• During first exposure to water there
• A fully equipped spare parts kit should
Problem
Awning tent
only inflates
with
difficulties
Part of the
awning tent
does not
inflate
4445103255
ing.
ensure the material will dry thoroughly.
may be some moisture at the seams.
Through this moisture the threads will
swell and fill the holes that are created
in the sewing process.
include:
– Waterproofer
– Repair tape and repair solution
– Silicone spray for the zippers
– Spare pegs
Solution
➤ Check that the valve is fully
screwed into the air pole.
➤ Check if the inflation tube is
twisted at the valve.This may be
indicated by noise. Untwist the
inflation tube.
➤ Check that the hand pump is
working.
➤ Check that all isolation valves that
connect the air poles are open.
13