Assembling The Frame - Toro Multi-Pro 5800 Installation Instructions Manual

2

Assembling the Frame

Parts needed for this procedure:
1 Support frame assembly
1 Locknut (3/8 inch)
1 Back plate assembly
1 Cradle arm, right
1 Cradle arm, left
2 Bushing
2 Pivot pin
2 Jam nut (3/8 inch)
2 Handle
2 Bolt (3/8 x 1-1/4 inches)
2 Set screw
2 Hair pin
2 Flat washer
Procedure
1. Remove the locknuts securing the wire lid stop to the
strap. Remove the wire lid stop. Retain all parts.
2. Locate the main support frame in loose parts.
3. Install the frame over the tank strap aligning the lower
hole in the frame with the exposed bolt in the side of
the tank strap and the upper hole with the upper bolt
in the tank strap as shown in
1
1. Main support frame
assembly
2. Exposed bolt, top
Figure 6.
2
3
4
G013925
Figure 6
3. Tank strap, rear
4. Exposed bolt, side
4. Install a lock nut over the lower exposed bolt passing
through the frame to secure it to the tank strap
7).
1
4
1. Main support frame
assembly
2. Exposed bolt, top
5. Install the wire tank lid stop removed previously over
the protruding threads of the carriage bolts in the
upper portion of the tank strap. The bow should face
forward to catch the main tank lid when opened.
6. Secure the lid stop and the upper portion of the
eductor frame to the tank assembly with two lock nut
removed previously. Torque the fasteners to 19-24
N-m (14-18 ft-lb).
7. Assemble the eductor cradle to the frame:
6
2
3
G013926
Figure 7
3. Exposed bolt, side
4. Lock nut (3/8 inch)
(Figure