Finishing The Installation - Toro Multi-Pro 5800 Installation Instructions Manual

Figure 23
1. Supply hose
2. Eductor valve assembly
5. Install the open end of the hose into the eductor valve
and secure the hose using a retainer pin
6. Slide the hose clamp over the fitting barb, and tighten
the clamp to secure the fitting to the hose.
7

Finishing the Installation

Parts needed for this procedure:
1 Suction lance and hose (optional)
Procedure
Note: The suction lance and hose are optional accessories.
Contact your Authorized Toro Distributor for more
information.
Retain the suction lance and hose for later use. Read and
retain the remaining documentation on using the Chemical
Pre-Mix Kit.
3. Retainer pin
(Figure 23).
13