Mode-Conditioning Patch Cord Description - Cisco CISCO7201 Installation And Configuration Manual

Chapter 2 Installing the Cisco 7201 Router
Caution If you plan to use a SFP-GE-L at distances greater than 984.25 feet (300 meters) over 50/125-micron or
62.5/125-micron multimode fiber, you must use the mode-conditioning patch cord to prevent data
transmission problems.

Mode-Conditioning Patch Cord Description

A mode-conditioning patch cord can be used with the SFP-GE-L= (SFP module) to allow reliable laser
transmission between the single-mode laser source on the SFP module and a multimode optical fiber
cable.
When an unconditioned laser source designed for operation on single-mode optical fiber is directly
coupled to a multimode optical fiber cable, an effect known as differential mode delay (DMD) might
result in a degradation of the modal bandwidth of the optical fiber cable.
This degradation results in a decrease in the link span (the distance between a transmitter and a receiver)
that can be supported reliably. The effect of DMD can be overcome by conditioning the launch
characteristics of a laser source. A practical means of performing this conditioning is to use a device
called a mode-conditioning patch cord.
A mode-conditioning patch cord is an optical fiber cable assembly that consists of a pair of optical fibers
terminated with connector hardware. Specifically, the mode-conditioning patch cord is composed of a
single-mode optical fiber permanently coupled off-center (see Offset in
multimode optical fiber.
Figure 2-17
2
RX
1
2
3
4
The mode-conditioning patch cord assembly is composed of duplex optical fibers, including a
single-mode-to-multimode offset launch fiber connected to the transmitter, and a second conventional
graded-index multimode optical fiber connected to the receiver. The use of a plug-to-plug patch cord
maximizes the power budget of multimode 1000BASE-LX and 1000BASE-LH links.
OL-11364-04
Figure 2-17
Mode-Conditioning Patch Cord Assembly for an SFP Module
1
TX
3
Gray color identifier
To Gigabit Ethernet interface
Blue color identifier
Multimode bar
shows a diagram of the mode-conditioning patch cord assembly.
4
/ /
/ / / /
Offset
5 6 4
5 Single-mode bar
6
Offset
7
Beige color identifier
8
To cable plant
Cisco 7201 Installation and Configuration Guide
Connecting I/O Cables
Figure 2-17) to a graded-index
7
8
7
2-21