Removing And Installing A Dc Power Supply; Removing The Dc Power Supply - Cisco CISCO7201 Installation And Configuration Manual

Removing and Installing a DC Power Supply

Slide the wire cable-retention clip to the right, over the power supply cable.
Step 5
Plug the power supply cable into the power source.
Step 6
On the front of the router, place the power switch in the on (O) position to turn on the router.
Step 7
You are finished replacing the AC power supply.

Removing and Installing a DC Power Supply

For DC power supply specifications and product numbers, see
This section provides information about removing and replacing a DC power supply. Because of the
power supply redundancy, there is no need to power off the Cisco 7201 router before removing one of
the DC power supplies.
The Cisco 7201 has two of the same type of power supplies in power supply slot 1 and power supply
slot 2. (See
supply, and to the right of the right power supply.
Figure 4-9
TH IS UN
IT MA Y
1

Removing the DC Power Supply

Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Cisco 7201 Installation and Configuration Guide
4-10
Figure 4-5.) The power supply slot numbers are on the chassis to the left of the left power
Power Supply Slot 1 and Slot 2
HA VE MO
RE TH AN
ON E PO
WE R SU
PP LY CO
NN EC TIO
N. AL L
CO NN EC
TIO NS MU
ST BE RE
MO VE D
TO DE -EN
ER GIZ E
TH E UN
IT
1
Power supply slot 1
Chapter 4 Replacing Cisco 7201 Field-Replaceable Units
Appendix A,
2
2
Power supply slot 2
"Specifications".
OL-11364-04