Table of Contents
Advertisement
Practical information
Changing a fuse
Access to the tools
The extraction tweezer and spare fuses are
fitted in the engine compartment fusebox.
To gain access to them:
Open the bonnet (refer to the "Checks"
section).
Unclip the and remove the cover.
Remove the tweezer.
Carefully close the cover to ensure correct
sealing of the fusebox.
194
Changing a fuse
Good
Before changing a fuse, the cause of the failure
must be identified and rectified.
Check that the switch is in the " LOCK "
position or that the vehicle mode is " OFF ".
Identify the failed fuse by checking the
condition of its filament.
Use the special tweezer to extract the fuse
from its location.
Always replace the faulty fuse with a fuse
of the same rating.
Check that the number etched on the box,
the rating etched on the top and the tables
below all agree.
The replacement of a fuse not
mentioned in the following tables may
cause a serious fault on your vehicle.
Contact a CITROËN dealer or a
qualified workshop.
Failed
Your vehicle's electrical system is
designed to operate with standard or
optional equipment.
Before installing other electrical
equipment or accessories in your
vehicle, contact a CITROËN dealer or a
qualified workshop.
CITROËN will not accept responsibility
for the cost incurred in repairing your
vehicle or for rectifying the malfunctions
resulting from the installation of
accessories not supplied and not
recommended by CITROËN and
not installed in accordance with its
instructions, in particular when the
consumption of all of the additional
equipment connected exceeds
10 milliamperes.
Advertisement
Table of Contents
