Table of Contents
Advertisement
www.ti.com
1 Setup
This section describes the test points and connectors on the EVM and how to properly connect, set up, and use
the LM63635DNEVM. Either the banana jacks on the top of the board or the card edge connector can be used
for connections. See
Figure 1-1
See the
LM636x5-Q1 3.5-V to 36-V, 1.5-A, and 2.5-A Automotive Step-down Voltage Converter Data Sheet
details. The following lists the functions of the connections:
VINEMI
Input supply to EVM. Connect to a suitable input supply.
GND
System ground.
VOUT
Output of EVM. Connect to desired load.
VOS
Output voltage sense connection (do not use for power; sense only).
VIS
Input voltage sense connection (do not use for power; sense only).
GNDS
Ground sense point for analog measurements (do not use for power; sense only).
SNVU767 – MARCH 2022
Submit Document Feedback
for the top of board connections and
Output
Voltage
DMM
(-)
(-)
Input Voltage
DMM
Figure 1-1. EVM Board Connections
Copyright © 2022 Texas Instruments Incorporated
Figure 1-2
for the card edge connections.
(+)
Input Power
Supply
(+)
LM63635DNEVM EVM User's Guide
Setup
for
(+)
LOAD
(-)
(-)
(+)
3
Advertisement
Table of Contents
