Installation; Unpacking; Connect Drain Hose - Whirlpool WFW6605MW Owner's Manual

INSTALLATION

Unpacking

WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
1. Move washer
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
Move washer to within 4 feet (1.2 m) of its final location. It
must be in a fully upright position.
2. Locate transport bolts
Locate four transport bolts on rear of washer.
3. Remove transport bolts from washer
Loosen bolts with a 5/8" (16 mm) wrench. Slide each bolt and
spacer to center of hole. Pull bolts and plastic spacers from
back of washer. Discard bolts and spacers.
IMPORTANT: Do not plug washer in until installation has
been completed.

Connect Drain Hose

4. Attach drain hose to drain port
A
If clamp is not already in place on elbow end of drain hose,
squeeze clamp with pliers and slide it over end of hose,
centering it between the ribs, as shown. Squeeze clamp with
pliers and slide elbow end of drain hose onto drain port and
secure with clamp.
For a laundry tub or standpipe drain, go to step 6.
For a floor drain, remove the preinstalled drain hose form as
shown in step 5. You may need additional parts with separate
directions. See "Alternate Parts."
It is the responsibility of the installer to install and secure the
drain hose into the provided plumbing/drain in a manner that
will avoid the drain hose coming out of or leaking from the
plumbing/drain.
A- - Ribs
13