Harman Kardon AVR 525 Owner's Manual page 35

Button , until the on-screen cursor is next to
the ADVANCED line. Press the Set Button
to enter the ADVANCED SELECT menu.
At the ADVANCED SELECT menu, make
certain that the on-screen cursor is next to the
SEMI OSD DEFAULT line by pressing the
/ Buttons as needed. Next, press the
Button 37 so that the word OFF is highlighted in
the video display.
This setting is temporary and will remain active only
until it is changed or until the AVR 525 is turned off.
Once the unit is turned off, the semi-OSD displays will
remain activated, even if they were switched off for the
previous listening session.
To change the length of time that the semi-OSD
displays remain on the screen, go to the ADVANCED
SELECT menu as outlined earlier, and press the
/ Buttons as needed, until the on-screen
cursor is next to the SEMI OSD TIME OUT
line. Next, press the / Buttons
desired time in seconds is displayed. Unlike most of
the other options in this menu, this is a permanent
setting change, and the time-out entry will remain in
effect until it is changed, even when the unit is turned off.
If you wish to make other adjustments, press the
/ Buttons until the on-screen
next to the desired setting or the BACK TO
MASTER MENU line and press the Set Button
. If you have no other adjustments to make, press
the OSD Button to exit the menu system.
Full-OSD Time-Out Adjustment
The FULL OSD menu system is used to simplify
the setup and adjustment of the AVR 525, using a
series of on-screen menus. The factory default setting
for these menus leaves them on the screen for 20
seconds after a period of inactivity before they disap-
pear from the screen (Time-Out). Time-Out is a safety
measure to prevent image retention of the menu text
in your monitor or projector, which might happen if it
were left on indefinitely. However, some viewers may
prefer a slightly longer or shorter period before the
Time-Out display.
To change the full-OSD Time-Out, you will need to
make an adjustment in the ADVANCED
SELECT menu (Figure 10). To start the adjust-
ment, press the OSD Button to bring the
MASTER MENU to the screen. Press the
Button , until the on-screen cursor is next to
the ADVANCED line. Press the Set Button
to enter the ADVANCED menu (Figure 10).
At the ADVANCED SELECT menu (Figure
10) make certain that the on-screen
to the FULL OSD TIME OUT line by press-
ing the / Buttons
the / Buttons
displayed in seconds. Unlike most of the other options
in this menu, this is a permanent setting change, and
the Time-Out entry will remain in effect until it is
changed, even if the unit is turned off.
If you wish to make other adjustments, press the
/ Buttons
next to the desired setting or the RETURN TO
MASTER MENU line and press the Set Button
. If you have no other adjustments to make, press
the OSD Button
37 until the
cursor is
cursor is next
as needed. Next, press
37 until the desired time is
until the on-screen cursor is
to exit the menu system.