Perform Other Configuration Tasks
To make advanced configuration changes after you establish the basic startup configuration for your router, refer to the Cisco
ASR 1000 Series Aggregation Services Routers Software Configuration Guide and modular configuration and modular
command reference publications in the Cisco IOS software configuration documentation set that corresponds to the software
release installed on your Cisco hardware. These publications contain additional information on using the configure command.
The configuration publications also provide information about the following tasks:
• Understanding command modes
• Booting and rebooting the router
• Understanding software packages and architecture for the Cisco ASR 1002 Router
• Software Upgrades
7
After Installation
Follow the instructions in this section to replace field-replaceable units (FRUs) after installation. The Cisco ASR 1002 Router
supports the following components as FRUs: Cisco ASR1000-ESP5, shared port adapters, and power supplies.
For a complete list of Cisco ASR 1000 Series Routers field replaceable units, see
Note
Services Routers Hardware Installation
The following topics are covered in this section:
Powering Off the Cisco ASR 1002 Router Safely, page 38
•
Replace the Cisco ASR1000-ESP5 or ASR1000-ESP10, page 39
•
•
Replace the Shared Port Adapters, page 40
•
Replace a Power Supply in the Cisco ASR 1002 Router, page 40
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Powering Off the Cisco ASR 1002 Router Safely
This section explains how to shut down the Cisco ASR 1002 Router. It is recommended that before turning off all power to the
chassis, you issue the reload command. This insures that the operating system cleans up all the file systems. Once the reload
operation is complete, then the Cisco ASR 1002 Router can be powered off safely.
To remove power from a Cisco ASR 1002 Router safely, follow this procedure and see the examples:
Slip on the ESD-preventive wrist strap that was included in the accessory kit.
Step 1
Enter the reload command.
Step 2
Confirm the reload command:
Step 3
Rmcp-2ru-1#reload
Proceed with reload? [confirm]
Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis
code
Step 4
After confirming the reload command, wait until the system bootstrap message displays before powering off the system.
System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)
Technical Support: tap://www.cisco.com/techsupport
Copyright (c) 2010 by cisco Systems, Inc.
38
Guide.
Cisco ASR 1000 Series Aggregation