Reassigning Device Control Selectors - Harman Kardon AVR 110 Owner's Manual

Programming the Remote
2. Press the Play button . The Program
Indicator will stop flashing and stay
amber.
3. Press and release the Input Selector button
for the device that will be used to change
the channels. The Program Indicator
blink green three times and then go out to con-
firm the data entry.
Example: To control the transport of a DVD
player while the remote is set to control the TV,
first press the VID 2/TV Input Selector but-
ton and the Mute button
35
same time. Next, release them and press the
Play button , followed by the DVD Input
Selector button .
NOTE: To remove the Channel Control Punch-
Through and return the remote to its original con-
figuration, repeat the steps shown in the example
above. However, press the VID 2/TV Input
Selector in Steps 1 and 3.
NOTE: Before programming the remote for
Volume, Channel or Transport Punch-Through,
make certain that any programming needed for
the specific TV, CD, DVD, Cable or Satellite
Receivers has been completed.
Reassigning Device Control
Selectors
Although each Input Selector
assigned to the category of product shown on the
remote, it is possible to reassign one of these but-
tons to operate a second device of another type.
For example, if you have two VCRs but no satellite
receiver, you may program the "SAT" button to
operate a second VCR. Before following the nor-
mal programming steps for either Three-Digit entry
or Auto Search code entry, you must first reassign
the button with the following steps:
1. Press the Input Selector you wish to
reassign and the Mute button 35
same time until the red light appears under the
Input Selector and the Program
Indicator flashes amber.
2. Press the Input Selector for the device
you wish to program into the reassigned
button.
3. Enter the three-digit code for the specific
model you wish the reassigned button to
operate.
30 PROGRAMMING THE REMOTE
4. Press the same Input Selector
Step 1 once again to store the selection. The
red LED under the reassigned Input Selector will
flash three times and then go out.
Example: To use the CBL/SAT button to oper-
will ate a second VCR, first press the CBL/SAT
Input Selector
35 at the same time until the red light glows
under the CBL/SAT
button, followed by the three-digit code
for the specific model you wish to control.
Finally, press the CBL/SAT
at the
Resetting the Remote Memory
As you add components to your home-theater sys-
tem, occasionally you may wish to totally repro-
gram the remote control without the confusion of
any commands, macros or "Punch-Through" pro-
gramming that you may have done. To do this, it is
possible to reset the remote to the original factory
defaults and command codes by following these
steps. Note, however, that once the remote is
reset, all commands or codes that you have
entered will be erased and will need to be re-
entered:
1. Press any of the Input Selector buttons
and the "O" button
the Program Indicator
amber.
2. Press the "3" button
is normally
3. The red LED under the Input Selector
go out and the Program Indicator
stop flashing and turn green.
4. The Program Indicator
until the remote is reset. Note that this may
take a while, depending on how many com-
mands are in the memory and need to be
erased.
5. When the Program Indicator
at the
the remote has been reset to the factory
settings.
pressed in
and the Mute button
button. Press the VCR
button again.
at the same time until
begins to flash
three times.
will
will
will remain green
goes out,