Page 2
AVR11 engelsk manual 11/01/98 10:45 Side 2 Declaration of Conformity We, Harman Kardon Europe A/S Kongevejen 194B DK-3460 Birkerød DENMARK declare in own responsibility, that the product described in this owner’s manual is in compliance with technical standards: EN 55 013/6.1990 EN 55 020/6.1988...
Page 3
AVR11 engelsk manual 11/01/98 10:45 Side 3 Front Panel & Ô Ó Volume Tuning/PTY Memory Display Seek Stereo Bass Treble Balance VCR1 VCR 2 Power Headphones Bypass Surround Tape Mon VCR 2 TV/Aux 8 Treble Control % PTY Search Button...
Page 4
AVR11 engelsk manual 11/01/98 10:45 Side 4 Rear Panel ¬ µ ñ ø π œ ® ß ANTENNA AC INPUT AC 230V~50Hz 450W å VIDEO LOOP LEFT RIGHT MADE IN KOREA VCR 1 MONITOR AC OUTLET CENTER MAIN SPEAKER (8Ω) SERIAL NO.
Page 5
AVR11 engelsk manual 11/01/98 10:45 Side 5 Remote Control a IR Transmitter Window b Standby Button c Tuning Up/Down harman kardon d Preset Scan e Numeric Buttons f CD Function Buttons Standby Tuning PScan g Cassette Deck Function Buttons / ON...
AVR11 engelsk manual 11/01/98 10:45 Side 6 Table of Contents Introduction and Safety Information ....1 Front Panel Controls......2–3 Rear Panel Connections .
Conventions immediately and consult an authorized years of superb performance. Harman Kardon service center. Using the In order to help you use this manual with unit under such conditions may cause a Save all packing material.
AVR11 engelsk manual 11/01/98 10:46 Side 2 Front Panel Controls 9 BALANCE Control: This control is used for balancing the relative sound volume of the left and right channel speakers. Clockwise rotation reduces the volume from the left speaker, counterclockwise rotation reduces the...
Page 9
AVR11 engelsk manual 11/01/98 10:46 Side 3 Front Panel Controls ^ RDS Selector: Press this button to activate the RDS-search-system. Note that RDS will appear in the display window. Pressing the TUNING/PTY & buttons will advance the tuner to the next available station that is transmitting RDS data.
Jack: Connect this jack to the video product with a mono 3.5mm cord set input (rec) of your VCR will enable the IR sensor in the AVR11 π VIDEO MONITOR Jack: Connect to pass remote commands through to additional devices.
Use these buttons to control the obstruct this window with any transport and disc selection functions material. of a compatible Harman Kardon CD player or CD changer. k CENTER MODE Button: STEREO TUNED...
Page 12
AVR11 engelsk manual 11/01/98 10:46 Side 6 System Remote Control q MUTE Button Press this button to silence the speakers temporarily. The VOLUME Ó indicator will blink. Press again to restore the previous listening level. r BATTERY COMPARTMENT To remove the cover, press it down with your thumb and pull it toward the back side.
(+) and negative (–) terminals 60 cm off center from the tweeter on the on the AVR11 to the like terminals on the center channel speaker. speakers. Surround Speaker Mounting Height...
Page 14
Installation & Configuration CENTER CHANNEL MODE SELECTION When Dolby ProLogic or Dolby 3 Stereo are in use the AVR11 permits you to tailor the center channel output to match the type of speakers used in your home CENTER MODE k theater.
Page 15
3. Sit in the location that you will all channels be as close to one another as normally occupy when using your AVR11. possible (with test signal). A small TEST l amount of time spent to properly 4.
TV Monitor connected to The AVR11’s built in tuner is capable of will turn green, the display will light and the AVR11. Be certain that your TV is set tuning AM, FM or FM Stereo broadcast the volume indicator mark Ó...
Page 17
11/01/98 10:46 Side 11 Operation RDS OPERATION Your AVR11 is equipped with RDS (Radio Data System), which brings a wide range of information to FM radio. Now in use in many countries, RDS is a system for 2. Within five seconds, press the station...
Page 18
Programme Search (PTY) A major benefit of RDS is its ability to encode broadcasts with Programme Type The AVR11 allows you to scan for a (PTY) codes that indicate the type of specific PTY by using the following steps: material being broadcast. The following...
Page 19
AVR11 engelsk manual 11/01/98 10:46 Side 13 Operation Dubbing from VCR2 to VCR1 1. Press the button to select the VCR2 6 input source. 2. Place the VCR connected to the VCR1 input in the “record” mode. 3. Start the VCR connected to the front panel inputs.
This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. So, if you have a problem, first check this list for a possible solution. If the problem persists, consult your authorized Harman Kardon Service Center.