MSI, continued
When Check Character is set to Validate, but Don't Transmit , the unit will only
read MSI bar codes printed with the specified type check character, but will not
transmit the check character with the scanned data.
* Validate Type 10, but Don't
Transmit
Validate Type 11, but Don't
Transmit
Message Length
The message length selection is used to set the valid reading length of the bar
code. If the data length of the scanned bar code doesn't match the valid reading
length, the scanner will issue an error beep. You may wish to set the same value
for minimum and maximum length to force the scanner to read fixed length bar
code data. This helps reduce the chances of a misread.
EXAMPLE: Decode only those bar codes with a count of 9-20 characters.
Min. length = 09
EXAMPLE: Decode only those bar codes with a count of 15 characters.
Min. length = 15
For a value other than the minimum and maximum message length defaults,
scan the bar codes below, then scan the 2-digit value and Save bar codes on the
Programming Chart inside the back cover. Minimum and Maximum
lengths = 4-48.
5 - 36
Validate Type 10 and Transmit
Validate Type 11 and Transmit
Max. length = 20
Max. length = 15
IMAGETEAM™ 3800E User's Guide